Check out our new Snap-on Tools Signature Series 80 gallon, 7 hp, 175 psi air compressor (model # BRA7180VEM). Whether you're looking to add a new compressor to your shop or looking to upgrade that cheap Chinese one that can’t handle your air needs, take a look at what Snap-on's got to offer.
-Industrial grade Baldor motor with two cooling fans, so it runs cooler, lasts longer and uses less energy
-ASME powder-coated tank with two outlets
-Built to industry standards
-Powder coat is resilient to rust and fading
-Versatile hook ups
-Powder coated steel and extruded steel belt guard for strength and durability, plus it resists rust and fading
-Circular base support with four legs for added stability
-Vibration pads (included) mount between the four legs and the floor, and helps reduce vibration and noise. Best of all the pads mean there is no need to bolt compressor to the floor
Performance:
-23.5 SCFM @ 175psi
-Quiet-72Db @ 6’
-Versatility-208/230V Single phase (Some shops have low voltage, requiring a special compressor from our competition. Snap-on can special-build you a 208/230V three phase or 460V compressor.)
Also, Snap-on's BRA7180V compressor has the following that BRA7180VEM does not have: an hour meter, ON/OFF breaker switch, automatic tank drain replaced with a manual drain, aluminum/cast iron pump replaced with a cast iron imported pump (BRA7180VEM is heavier because of the cast iron pump)
AND...
All Snap-on Signature Series Air Compressors meet code requirements for ASME and the State of California.